Electronics Line Penta XL series Manuale di Installazione Scaricare il pdf (Pagina 14)

-14-

3.6: User Codes

The control panel supports four user codes, a duress code and an installer code. Each of

these codes are four digits long. Of the four user codes, only User Code 1 (default 1111)

has authorization to modify other user codes and the duress code. The installer’s code

(default 1234) is the only user code which grants access to the programming parameters

and is programmable at address 83.

To program user codes 1-4:

1. Press 4, 5.

2. Enter User Code 1; the Armed and System LEDs flash and the zone LEDs

indicate the programming status of each user code as follows:

Off:

Not Programmed

On:

Programmed

Flashing:

Currently Being Programmed

3. Enter the number of the code to be changed (1-4); the requested zone LED

flashes.

4. Enter the new user code; the LED stops flashing.

5. Enter the next code to be changed or press # to exit.

Note: If the new code is identical to an existing user code, an error tone will be

sounded and the new code will not be accepted.

To erase a user code:

1. Press 4, 5.

2. Enter User Code 1.

3. Enter the number of the code to be erased (1-4); the requested zone LED

flashes.

4. Enter 4, 4, 4, 4; the LED stops flashing and the code is erased.

5. Enter the next code to be erased or press # to exit.

Note: Do not erase User Code 1! Erasing this code denies the user the ability to

program user codes. If User Code 1 is accidentally erased, reset the default

program as described in 2.5: Turning on the System.

Duress Code

In the event that the user is forced to disarm the system and/or cancel the bell, entering

the duress code will send a silent alarm to the central station.

To program the duress code:

1. Press 4, 5.

2. Enter User Code 1.

3. Press 5; the Ready LED flashes.

4. Enter a new duress code or 4, 4, 4, 4 to erase the existing code.

5. Press # to exit.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 32 33

Nessun commento

Electronics Line Penta XL series Manuale di Installazione Pagina 14