Electronics Line Penta XL series Manuale di Installazione Scaricare il pdf (Pagina 12)

-12-

ARMED: The Armed LED lights to indicate the system is armed or in programming

mode and flashes during the exit delay.

POWER: The Power LED lights up when both AC & battery power are OK, flashes

when the battery is low & AC power is OK, and goes out in the event of AC failure.

3.3: Command Codes

To execute a command, press the ‘4‘ button followed by the corresponding command

number. In certain cases, you are required to enter a valid user code.

The following is a summary of the command codes used in system operation.

Quick Arm

45 + (User Code 1)

Program User Codes

41 + (User Code)

Bypass Mode

Zone Chime

Emergency/

Trouble Event Log

47 + (Installer Code)

Programming Mode

Zone Alarm

Event Log

48 + (User Code)

Forced Arming

441

442 + (User Code 1)

Bell/LED Test

Walk Test

49 + (User Code)

ENTER 1 + (User Code 1)

Stay Arming

Stop Communications

3.4: Arming/Disarming

The following section explains the various arming and disarming methods.

Arming

When all zones are secured, you can arm the system normally. Arming the system sends a

message to the central station identifying which user performed the operation.

To arm the system:

1. Check that all zones are closed; the Ready LED lights up to indicate that the

system is ready to be armed.

2. Enter a valid user code; the keypad beeps until the end of the exit delay.

Forced Arming

Forced arming enables you to arm the system with open zones. Electronics Line 3000

recommends waiting until all of the zones are secured and the system can be armed

normally.

Note: If zones are still not secured after the exit delay has ended, an alarm will be generated.

To force arm the system:

1. Press 4, 8.

2. Enter a valid user code; the keypad beeps until the end of the exit delay.

Quick Arming

This feature enables you to arm the system without a valid user code. Quick arming the

system transmits an “Armed by User 1” message to the central station.

To “Quick” arm the system:

1. Check that all zones are closed; the Ready LED lights up to indicate that the

system is ready to be armed.

2. Press 4, 0; the keypad beeps until the end of the exit delay.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 32 33

Commenti su questo manuale

Nessun commento

Electronics Line Penta XL series Manuale di Installazione Pagina 12

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Electronics Line Penta XL series