Electronics Line Penta XL series Manuale di Installazione Scaricare il pdf (Pagina 10)

-10-

You can connect up to 3 individually addressed LED keypads to the control panel.

To mount the keypad:

1. Separate the front and back cover of the keypad by pressing the locking tabs,

situated at the bottom of the keypad, with a small flathead screwdriver.

2. Pull the keypad wires through the opening in the back cover nearest the

terminal block and mount the back cover to the wall.

3. Define the keypad address by configuring jumpers A & B according to the

following diagram.

Jumper

Removed

Keypad 3Keypad 2Keypad 1

BABAB A

Jumper

Installed

Figure 2.6: Keypad Jumper Configuration

4. Connect the keypad to the control panel according to the following diagram.

CONTROL PANEL

KEYPAD

Figure 2.7: Keypad Connections

5. Reassemble the front and back cover of the keypad.

2.5: Turning on the System

Once all of the systems components are properly connected to their destination terminals,

you are ready to turn the system on. To avoid the risk of electrical shock or damage to the

control panel, make sure that both the AC supply and the battery are connected properly

before plugging in the system. If you experience any difficulties in applying power to the unit,

please contact Electronics Line 3000’s Technical Support Department. The panel is

supplied with a default program that includes typical programming data which means that

minimum programming is required for typical installations.

To turn on the system:

1. Install the JPD jumper located on the control panel board.

2. Reapply power and wait for 10 seconds; the keypad beeps to indicate the end of

the 10 second period.

3. Disconnect both the AC and battery power supply.

4. Remove the JPD jumper.

5. Reapply power and wait for 10 seconds; the keypad beeps to indicate that the

default program has been restored.

The default settings can be reset at any time by disconnnecting the power supply and

repeating the above procedure.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 32 33

Nessun commento

Electronics Line Penta XL series Manuale di Installazione Pagina 10